6.1.2 Active/Hot Removal Workflow of the HDD/SSD
6.1.2 Active/Hot Removal Workflow of the HDD/SSD
Before removing the HDD/SSD, see "Precautions for HDD/SSD removal" in "7.3 Precautions for FRU Reduction."
Table 6-2 shows the workflow for active/hot removal of the HDD/SSD.
Work Order | Task | Reference |
---|---|---|
1 | Checking the operating condition of the system | "9.2.1 Checking the Operation Status of Physical Partitions and Logical Domains" |
2 | Checking the usage status of the HDD/SSD to be removed | "9.2.3 Checking the Usage of the HDD/SSD" |
3 | Releasing the HDD/SSD from the system | "9.4 Enabling the Removal of Hardware" |
4 | Confirming that you can remove the HDD/SSD to be removed | "9.2.3 Checking the Usage of the HDD/SSD" |
5 | Saving logical domain configuration information | "9.1.1 Saving Logical Domain Configuration Information" |
6 | Switching the mode switch on the OPNL to Service | "2.3.2 OPNL Control Function" |
7 | Removing the HDD/SSD from the SPARC M12-2/M12-2S | "15.3.1 Removing an HDD/SSD" |
8 | Checking the operating condition of the physical partition and logical domains (*1) | "9.2.1 Checking the Operation Status of Physical Partitions and Logical Domains" |
9 | Installing the filler unit in the SPARC M12-2/M12-2S | "15.4.2 Installing a Filler Unit" |
10 | Switching the mode switch on the OPNL to Locked | "2.3.2 OPNL Control Function" |
*1 Reassign I/O resources to logical domains as required. For details, see "Chapter 3 Operations for Domain Configuration" in the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 Domain Configuration Guide. |
< Previous Page | Next Page >