10.1.2 Securing the Cable Support
10.1.2 Securing the Cable Support
After completing the FRU maintenance at the rear of the SPARC M12, lift and secure the cable support.
- Lift the cable support, and push (in the directions of the arrows) the brackets above and below the screws to lock the cable support.
Figure 10-3 Locking the Cable Support
|
![]() |
- Tighten the left and right screws (A in Figure 10-4) to secure the cable support.
Figure 10-4 Securing the Cable Support
|
![]() |
Note - Confirm that the cable support is firmly installed and secured. |
< Previous Page | Next Page >