Chapter 10 Setting Up the System
Chapter 10 Setting Up the System
This chapter describes the system setup work to be done after a FRU is replaced, added, or removed or after the building block configuration is changed. See this chapter, as required, after replacing, adding, or removing a FRU.
- Preparing Hardware
- Restoring Setting Information
- Adding the SPARC M12-2S to a Building Block Configuration
- Incorporating a FRU Into the System
- Diagnosing a Replacement FRU
- Incorporating the SPARC M12-2S or an I/O Device Into the PPAR
- Incorporating I/O Resources Into a Logical Domain
- Powering on a Physical Partition
- Starting the System
< Previous Page | Next Page >