Skip to main content
  1. Home >
  2. Products >
  3. Computing Products >
  4. Servers >
  5. Fujitsu SPARC servers >
  6. Downloads >
  7. User Manuals >
  8. Fujitsu SPARC M12-2/M12-2S Service Manual >
  9. 4.4.6 Inactive/Cold Replacement Workflow of the HDD/SSD

4.4.6 Inactive/Cold Replacement Workflow of the HDD/SSD


4.4.6 Inactive/Cold Replacement Workflow of the HDD/SSD
You can perform inactive/cold replacement of the HDD/SSD in the following configuration:
  1. Building block configuration where two or more physical partitions are operating
Table 4-34 shows the workflow for inactive/cold replacement of the HDD/SSD.
Table 4-34  Inactive/Cold Replacement Procedure of the HDD/SSD
Work Order Task Reference
1 Checking the operating condition of the system "9.2.1 Checking the Operation Status of Physical Partitions and Logical Domains"
2 Confirming the HDD/SSD to be replaced "8.2 Troubleshooting"
3 Checking the operation status of the SPARC M12-2S that houses the HDD/SSD to be replaced "Figure 2-16 LED Locations on the HDD/SSD"
4 Powering off the physical partition containing the SPARC M12-2S that houses the HDD/SSD requiring maintenance "9.5.1 Stopping a Specific Physical Partition"
5 Switching the mode switch on the OPNL to Service "2.3.2 OPNL Control Function"
6 Releasing the SPARC M12-2S requiring maintenance from the building block configuration "9.6.1 Releasing the SPARC M12-2S From the Building Block Configuration"
7 Placing the SPARC M12-2S requiring maintenance into the cold state "9.8.2 Removing the Power Cords"
8 Removing the HDD/SSD from the SPARC M12-2S "15.3.1 Removing an HDD/SSD"
9 Installing an HDD/SSD in the SPARC M12-2S "15.4.1 Installing an HDD/SSD"
10 Placing the SPARC M12-2S that required maintenance into the hot state "10.1.1 Installing a Power Cord"
11 Incorporating the SPARC M12-2S that required maintenance into the building block configuration "10.4.1 Incorporating the SPARC M12-2S Into a Building Block Configuration"
12 Diagnosing the SPARC M12-2S requiring maintenance "10.5.1 Diagnosing the SPARC M12 Hardware"
13 Powering on the physical partition containing the SPARC M12-2S that underwent maintenance "10.8 Powering on a Physical Partition" (*1)
14 Confirming that there is no problem with the replacement HDD/SSD "10.5.3 Checking the FRU Status After Maintenance"
15 Switching the mode switch on the OPNL to Locked "2.3.2 OPNL Control Function"
16 Checking the operating condition of the system "9.2.1 Checking the Operation Status of Physical Partitions and Logical Domains"
*1 Do not switch the mode switch on the OPNL to Locked at this point.