5.1.1 Active/Hot Addition Workflow of a PCIe Card
5.1.1 Active/Hot Addition Workflow of a PCIe Card
Before adding the PCIe card, see "Precautions for PCIe card addition" in "7.2 Precautions for FRU Expansion."
Table 5-1 shows the workflow for active/hot addition of a PCIe card using the PCI Hot Plug function.
Work Order | Task | Reference |
---|---|---|
1 | Checking the operating condition of the system | "9.2.1 Checking the Operation Status of Physical Partitions and Logical Domains" |
2 | Switching the mode switch on the OPNL to Service | "2.3.2 OPNL Control Function" |
3 | Removing the PCICS from the SPARC M12-2/M12-2S or PCI expansion unit | "12.3.1 Enabling the Removal of a PCIe Card" |
4 | Removing the PCIe card filler of the PCICS | "12.3.2 Removing a PCIe Card or PCIe Card Filler" |
5 | Installing a PCIe card in the PCICS to install it in the SPARC M12-2/M12-2S or PCI expansion unit | "12.4.1 Installing a PCIe Card or PCIe Card Filler" |
6 | Incorporating the added PCIe card into the system | "10.6.2 Incorporating an I/O Device Into the Physical Partition by Using the Hot Plug Function" |
7 | Confirming that there is no problem with the added PCIe card | "10.5.3 Checking the FRU Status After Maintenance" |
8 | Switching the mode switch on the OPNL to Locked | "2.3.2 OPNL Control Function" |
9 | Assigning the I/O resource to a logical domain | "3.2 Operations and Commands Related to Logical Domain Configurations" in the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 Domain Configuration Guide |
< Previous Page | Next Page >