Skip to main content

5.6 System-Stopped/Cold Addition Workflows

5.6 System-Stopped/Cold Addition Workflows
This section describes the workflows for system-stopped/cold addition of FRUs to the SPARC M12-2/M12-2S, and the workflow for system-stopped/cold addition of a SPARC M12-2S to another SPARC M12-2S.
The described procedures are performed after all the SPARC M12-2/M12-2S units are placed in the cold state, without using the maintenance menu.
Note that, in a building block configuration, you can perform maintenance using the maintenance menu when only the SPARC M12-2S requiring maintenance is in the cold state. For work procedures with the maintenance menu, see "5.4 Inactive/Cold Addition Workflows."
Before performing addition work, be sure to check the notes on maintenance work in the Fujitsu SPARC M12 Product Notes of the XCP version used.
Each of the following sections puts together the order of work and the tasks for each FRU into a table. For details on each task, see the reference shown in the table.
The following FRUs are subject to system-stopped/cold addition: