6.2.3 Stopping the Whole System
6.2.3 Stopping the Whole System
Use the poweroff command of the XSCF firmware to stop the whole system.
Execute the command with a user account that has the platadm or fieldeng privilege.
Execute the command with a user account that has the platadm or fieldeng privilege.
Note - In Locked mode, power-off is not possible from the POWER switch on the operation panel on the chassis that has the master XSCF. For details on Locked mode, see "Chapter 13 Switching to Locked Mode/Service Mode." |
XSCF> poweroff -a |
To stop the whole system, execute the poweroff command with the -a option specified. Execution of the command outputs a confirmation message. Enter "y".
After the command is executed, the logical domains in each physical partition are shut down in accordance with the ordered shutdown rules. Then, the physical partition itself is powered off.
Operation Procedure
- Execute the poweroff -a command to power off the whole system. Enter "y" for the confirmation message.
XSCF> poweroff -a PPAR-IDs to power off:00,01,02,03 Continue? [y|n] :y 00 : Powering off 01 : Powering off 02 : Powering off 03 : Powering off *Note* This command only issues the instruction to power-off. The result of the instruction can be checked by the "showpparprogress". XSCF> |
- All the logical domains in each physical partition are shut down, and then all the physical partitions are powered off.
- Execute the showpparstatus command, and confirm that the power of all the physical partitions in the system is off.
XSCF> showpparstatus -a PPAR-ID PPAR Status 00 Powered Off 01 Powered Off 02 Powered Off 03 Powered Off |
< Previous Page | Next Page >