14.2.2 FCode Utility Commands
14.2.2 FCode Utility Commands
The FCode utility is used to configure hardware RAID. The utility provides the following commands.
FCode Command | Description |
---|---|
show-children | Lists all the connected logical drives and logical volumes. |
show-volumes | Lists the details of all the connected logical volumes. |
create-raid0-volume | Creates a RAID0 volume. Specify at least 2 targets. |
create-raid1-volume | Creates a RAID1 volume. Specify 2 targets. |
create-raid1e-volume | Creates a RAID1E volume. Specify at least 3 targets. Note - If this command is used with an even number of targets (at least 4 targets) specified, the command configures the hardware RAID as RAID10. |
create-raid10-volume | Creates a RAID10 volume. Specify at least 4 targets. Note - If this command is used with an odd number of targets (at least 5 targets) specified, the command configures the hardware RAID as RAID1E. |
delete-volume | Deletes a RAID volume. |
activate-volume | Enable a RAID volume again after replacing CPU memory units (lower) of the SPARC M12-2/M12-2S/M10-4/M10-4S and motherboard units of the SPARC M12-1/M10-1 systems. |
< Previous Page | Next Page >