4.3.1 Enabling Dual Power Feed
4.3.1 Enabling Dual Power Feed
Use the setdualpowerfeed command of the XSCF firmware to enable dual power feed.
XSCF> setdualpowerfeed {-a|-b bb_id} -s enable |
To target all chassis in the system, specify -a.
To target only a given chassis in the system, specify -b bb_id. For bb_id, specify the BB-ID of the chassis. You can specify an integer from 0 to 15 or 80 to 83, depending on the system configuration.
To target only a given chassis in the system, specify -b bb_id. For bb_id, specify the BB-ID of the chassis. You can specify an integer from 0 to 15 or 80 to 83, depending on the system configuration.
Operation Procedure
- Enable dual power feed with the setdualpowerfeed command.
The following example enables dual power feed for BB-ID 1.
XSCF> setdualpowerfeed -b 1 -s enable BB#01:disable -> enable NOTE: Dual power feed will be enabled the next time the platform is powered on. |
< Previous Page | Next Page >