16.7 Firmware Version Matching with Parts Addition/Replacement
16.7 Firmware Version Matching with Parts Addition/Replacement
This section describes the firmware version matching when parts are added/replaced.
In a building block configuration, firmware is automatically updated during replacement of parts or addition of the SPARC M12-2S/M10-4S in order to match firmware versions in the system.
The following parts are targets:
In a building block configuration, firmware is automatically updated during replacement of parts or addition of the SPARC M12-2S/M10-4S in order to match firmware versions in the system.
The following parts are targets:
- XSCF unit in the SPARC M12-2S
- CPU memory unit lower in the SPARC M10-4S
- XSCF unit in the crossbar box
Note - Replace/Add parts one by one. If multiple SPARC M12-2S/M10-4S servers are replaced/added at the same time, firmware is not automatically updated to match firmware versions. Update the firmware manually. |
When parts are replaced or added in the systems described below, firmware is not automatically updated to match firmware versions. Update the firmware manually.
- System not in a building block configuration
- System with a crossbar box added
- SPARC M10-4S with an XCP version that does not support automatic update, and the maintenance menu is not used
For information on automatic update support for the SPARC M10-4S, see the Fujitsu M10/SPARC M10 Systems Product Notes for the latest XCP version.
< Previous Page | Next Page >