Skip to main content

6.8.1 Starting the system with an XSCF command


6.8.1 Starting the system with an XSCF command
  1. Check that the XSCF STANDBY LED on the operation panel is on.
  2. Log in to the XSCF shell.
  3. Execute the poweron command.
    Enter "y" in response to the confirmation message.
XSCF> poweron -a
PPAR-IDs to power on:00,01
Continue? [y|n] :y
00 : Powering on
01 : Powering on
  1. Confirm that the POWER LED on the operation panel is on.
  2. Execute the showpparstatus command to confirm that the power to all the physical partitions in the system is turned on.
  3. Confirm that no error remains by using the fmadm faulty command in the logical domain in which an error was detected.
# fmadm faulty
  1. If any error remains, clear the error by using the fmadm repaired command.