13.5.1 Removing the PSU backplane unit
13.5.1 Removing the PSU backplane unit
This section describes the procedure for removing the PSU backplane unit from the SPARC M10-4/M10-4S. Enable the removal of the PSU backplane unit before attempting to remove it. For details, see "Chapter 7 Maintenance Flow."
|
- Loosen the two screws in the fan slot and then remove the fan shelf.
Figure 13-4 Screws in the fan slot
|
![]() |
- Loosen the two screws securing the PSU backplane unit and then partially pull out the PSU backplane unit.
Figure 13-5 Screws securing the PSU backplane unit
|
![]() |
- Pull the PSU backplane unit out a little more. Then, remove the unit by holding its handle.
Note - Place the removed PSU backplane unit on a grounded antistatic ESD mat. |
Figure 13-6 Handle of PSU backplane unit
|
![]() |
< Previous Page | Next Page >