Skip to main content

6.1.4 Attaching the crossbar cables to the cable support


6.1.4 Attaching the crossbar cables to the cable support
After maintenance with the crossbar cables removed is done in a building block configuration of the SPARC M10-4S, restore the cables to their original state.
  1. Connect the crossbar cables to the cable support.
    Perform this procedure only when equipment rack model 26xx or equipment rack model 16xx is used. The procedure may vary depending on the model of the equipment rack.
  1. Procedure when equipment rack model 26xx is used
  1. a. Remove the hook-and-loop fastener of the crossbar cables from the cable holder.

    b. Remove the screw securing the cable holder, and then rotate the cable holder by 180 degrees to install it on the supporting column at the rear of the rack.

    c. Connect all the crossbar cables to the crossbar unit.
    For details, see "14.4  Installing the Crossbar Cables."

    d. Use the hook-and-loop fastener to fix the crossbar cables in place to the cable support.
  1. Procedure when equipment rack model 16xx is used
  1. a. Remove the crossbar cables from the hook-and-loop fastener installed on the supporting column at the rear of the rack.

    b. Connect all the crossbar cables to the crossbar unit.
    For details, see "14.4  Installing the Crossbar Cables."

    c. Use the hook-and-loop fastener to fix the crossbar cables in place to the cable support.
Note - Connect the crossbar cables in their original positions by referring to the notes that you made before the start of maintenance.