Skip to main content

14.2 Configuration of the Crossbar Cable Connection Ports


14.2 Configuration of the Crossbar Cable Connection Ports
This section describes the configuration and locations of the crossbar cable connection ports.
The crossbar cables are used to connect the SPARC M10-4S units to one another or to connect the SPARC M10-4S to a crossbar box in a building block configuration (with a crossbar box).
Each crossbar cable has a number that corresponds to a port number on the chassis. A port number is assigned to each pair of ports. So crossbar cables should be replaced as a pair.
Figure 14-1  Crossbar cable connection port (SPARC M10-4S)
Figure 14-1  Crossbar cable connection port (SPARC M10-4S)
Figure 14-2  Crossbar cable connection port (crossbar box)
Figure 14-2  Crossbar cable connection port (crossbar box)
Figure 14-3  Crossbar cables (electrical)
Figure 14-3  Crossbar cables (electrical)
Location number Component
Crossbar cables (electrical) (CBL)
Figure 14-4  Crossbar cables (optical) (SPARC M10-4S)
Figure 14-4  Crossbar cables (optical) (SPARC M10-4S)
Figure 14-5  Crossbar cables (optical) (crossbar box)
Figure 14-5  Crossbar cables (optical) (crossbar box)
Location number Component
Crossbar cables (optical) (CBL)