Skip to main content

3.3 Inactive Maintenance


3.3 Inactive Maintenance
The type of maintenance performed with the physical partition stopped--the one to which the chassis requiring maintenance belongs--is referred to as inactive maintenance. You can perform inactive maintenance only for a system that uses the SPARC M10-4S in a building block configuration.
Table 3-4 shows whether inactive maintenance is enabled for each FRU.
Table 3-4  Whether inactive maintenance (replacement/addition/removal) is enabled for each FRU
-: Maintenance cannot be performed.
FRU Building block configuration
Inactive/hot maintenance Inactive/cold maintenance
CPU memory unit - OK
Memory - OK
Crossbar unit - OK
Power supply unit OK OK
Fan unit OK OK
Internal disk OK OK
PCIe card OK OK
PSU backplane unit - OK
Operation panel - OK
Crossbar cable - OK
XSCF BB control cableĀ  - OK
XSCF DUAL control cableĀ  - OK