Skip to main content

6.1.2 Fixing the cable support


6.1.2 Fixing the cable support
After performing maintenance on a FRU at the rear of the SPARC M10-4/M10-4S, lift the cable support and fix it in place.
  1. Lift the cable support and lock it in place by pushing the upper and lower screw fittings toward the back (direction of the arrow).
Figure 6-3  Locking the cable support
Figure 6-3  Locking the cable support
  1. Tighten the right and left screws to fix the cable support in place.
Note - Check that the cable support is firmly attached and fixed.