Skip to main content

17.3 Removing an XSCF DUAL Control Cable


17.3 Removing an XSCF DUAL Control Cable
This section describes the procedure for removing an XSCF DUAL control cable.
Enable the removal of the XSCF DUAL control cables before attempting to remove them. For details, see "Chapter 7  Maintenance Flow."
Caution - Before you handle the XSCF DUAL control cables, wear a wrist strap to ground any static electricity. If you perform this procedure without a wrist strap, individual components or the overall system may be damaged. For details, see "1.5  Precautions on Static Electricity."
  1. Remove the XSCF DUAL control cables from the SPARC M10-4S or the crossbar box.
    Pull out the XSCF DUAL control cable while pushing the lock release buttons (A in the figure) on the both sides of the cable.
Note - The cables at the rear of the crossbar box are bundled together and fastened to the right-hand cable support with a hook-and-loop fastener. To remove the XSCF DUAL control cables, therefore, remove the hook-and-loop fastener from the cable support.
Figure 17-3  Removing the XSCF DUAL control cables (SPARC M10-4S)
Figure 17-3  Removing the XSCF DUAL control cables (SPARC M10-4S)
Figure 17-4  Removing the XSCF DUAL control cables (crossbar box)
Figure 17-4  Removing the XSCF DUAL control cables (crossbar box)
  1. Remove the XSCF DUAL control cables from the other chassis.
    Pull out the XSCF DUAL control cable while pushing the lock release buttons on the both sides of the cable.