Skip to main content

7.3.1 Configuring the Telnet service


7.3.1 Configuring the Telnet service
This section describes how to configure the Telnet service.
  1. Execute the showtelnet command to display the Telnet setting.
    The following example displays the Telnet service setting. The factory default setting is "disabled".
XSCF> showtelnet
Telnet status: disabled
  1. Execute the settelnet command to configure the Telnet service.
    The following example specifies that the Telnet service be enabled.
XSCF> settelnet -c enable
Continue? [y|n] :y
  1. Execute the showtelnet command, and confirm that the Telnet setting is "enabled".
XSCF> showtelnet
Telnet status: enabled