Skip to main content
  1. Home >
  2. Products >
  3. Computing Products >
  4. Servers >
  5. Fujitsu SPARC servers >
  6. Downloads >
  7. User Manuals >
  8. Fujitsu M10-4S/SPARC M10-4S Installation Guide >
  9. 3.1 Preparing the Necessary Tools/Information for Installation

3.1 Preparing the Necessary Tools/Information for Installation


3.1 Preparing the Necessary Tools/Information for Installation
This section describes the tools and information that are required in installation. Have these prepared before starting installation work.
Table 3-1  List of necessary tools
Name Use
Phillips screwdriver (#2) Used to attach cable support brackets and mount optional components
Phillips screwdriver (#3) Used to connect racks and attach rails to the rack supporting columns
Wrench or box wrench (M8 screws securing rack package: nominal size 13)  Used to unpack an ordinary rack package
Wrench or box wrench (M10 screws securing rack package: nominal size 17) Used to unpack an ordinary rack package
Allen wrench (M12 screws securing top cover: nominal size 8) Used to connect racks
Wrench or box wrench (upper connecting screw M12: nominal size 19) Used to connect racks
ESD mat and antistatic wrist strap Used in the work of mounting optional components
Lifter
(hydraulic or mechanical jack)
Used in the work of mounting chassis in racks
System management terminal
(ASCII terminal, workstation, terminal server, patch panel connected to terminal server, etc.)
Used to connect to the XSCF and for the work of checking and configuring the XSCF firmware