Skip to main content

6.2.1 Checking the BB-ID setting


6.2.1 Checking the BB-ID setting
Confirm that the BB-IDs are set properly before turning on the input power.
Note - If a BB-ID is not set or incorrectly set when the input power is turned on, the XSCF does not start normally. Therefore, confirm that the BB-ID settings are correct.
  1. Check the BB-IDs on the operation panel on the front of the SPARC M10-4S chassis.
    Confirm that BB-IDs 00 to 15 are set sequentially.
  1. Check the BB-IDs on the operation panel on the front of the crossbar box chassis.
    Confirm that BB-IDs 80 to 83 are set sequentially.
    For details on setting them, see "4.1 Setting the ID (BB-ID) Identifying a Chassis."