A.5 For Installation of the System Board Configured by the SPARC64 X+ Processor to the Physical Partition Configured Only by the SPARC64 X Processor
A.5 For Installation of the System Board Configured by the SPARC64 X+ Processor to the Physical Partition Configured Only by the SPARC64 X Processor
This section gives an example of environment establishment that has a SPARC64 X+ processor mounted on a SPARC M10-4S added to the physical partition in SPARC M10. The physical partition has the mounted SPARC64 X processor to which the XCP firmware of XCP 2210 or earlier was applied. This section also gives a procedural example.
< Previous Page | Next Page >