20.3.1 For the SPARC M12-2S
20.3.1 For the SPARC M12-2S
- Remove all the power cords of the SPARC M12-2S and crossbar box from the PDU requiring maintenance.
- Remove the three PDU screws.
Figure 20-5 PDU Screws
|
![]() |
- Grasp the tabs on the right side of the PDU and pull it out.
Figure 20-6 Pulling Out the PDU
|
![]() |
- Remove all the power cords from the rear of the PDU.
Figure 20-7 Power Cord of the PDU
|
![]() |
Turn the ring (A in Figure 20-8) counterclockwise to pull out each power cord connected to the PDU.
Figure 20-8 PDU Power Cord Connector
|
![]() |
< Previous Page | Next Page >