Skip to main content

12.4 Installing the Management Cable


12.4 Installing the Management Cable
This section describes the procedure for installing the management cable.
  1. Hold the connector of the management cable, and connect the management cable to the link board mounted on the PCI expansion unit.
Note - Confirm that the management cable is securely connected.
  1. Connect the management cable to the link card mounted in the SPARC M12-1/M12-2/M12-2S/M10-1/M10-4/M10-4S in the same way.
Note - Confirm that the management cable is securely connected.
Now, the work for mounting the FRU is complete. See "Chapter 7 Maintenance Flow" to continue maintenance work.