Skip to main content

2.4.1 Operation Panel LEDs


2.4.1 Operation Panel LEDs
The three LEDs on the operation panel indicate the operation status of the entire system. In addition, the LEDs enable you to check the system status by their combination of being on, blinking, or off. For the locations of the LEDs, see Figure 2-8.
Table 2-6 lists the system operation status indicated by the LEDs, while Table 2-7 lists the system status indicated by the combination of LEDs.
Table 2-6  System Operation Status Indicated by LEDs
Icon Name Color State Description
power POWER Green On The system is running.
Blinking The system is being stopped.
- Off The system is stopped.
xscf standby XSCF
STANDBY
Green On The XSCF is functioning normally.
Blinking The XSCF is being initialized.
- Off The XSCF is stopped.
check CHECK Amber On Hardware has detected an error.
Blinking The SPARC M12-1 specified at execution of the XSCF command instructing the blinking. This (locator) is used to identify the location of the SPARC M12-1 requiring maintenance.
- Off Normal state, or the power is disconnected or otherwise not being supplied.
Table 2-7  System Status Indicated by a Combination of LEDs
LED State Description
POWER XSCF
STANDBY
CHECK
power xscf standby check
Off Off Off The power is disconnected.
Off Off On The XSCF has detected an error before system start or after system stop.
Off Blinking Off The XSCF is being initialized.
Off On Off The XSCF is in the standby state.
Or the system is waiting for power-on of the air conditioning facilities (in the data center).
On On Off Warm-up standby processing is in progress. After the end of this processing, the system starts up.
Or the system startup processing is in progress.
Or the system is in operation.
On On On Although the system is operating normally, an error has been detected.
Blinking On Off System stop processing is in progress. After the end of processing, the fan unit stops.