Problems Resolved in XCP 2322
Problems Resolved in XCP 2322
The following table lists the problems resolved in XCP 2322.
RTI No. | RTIF2-161013-001 |
Model | SPARC M10-1, SPARC M10-4, SPARC M10-4S |
Description | If IP addresses are set to both XSCF-LAN#0 and XSCF-LAN#1, the XSCF-LAN#1 IP address may be set as the Agent Address for the SNMP Trap of SNMPv1. Therefore, a retry by resource management software (ServerView Resource Orchestrator) to switch the servers may fail. This symptom occurs when no takeover IP address is set for the SPARC M10-4S. |
Workaround | There is no effective workaround. |
RTI No. | RTIF2-161004-001 |
Model | SPARC M10-1, SPARC M10-4, SPARC M10-4S |
Description | The OID information of scfPPARStatus (PPAR status information) in the definition file of the XSCF extension MIB is not updated even when the control domain is rebooted. Therefore, a retry by resource management software (ServerView Resource Orchestrator) to switch the servers may fail. |
Workaround | There is no effective workaround. |
RTI No. | RTIF2-161004-002 |
Model | SPARC M10-1, SPARC M10-4, SPARC M10-4S |
Description | If you mount an IHV graphics card on a PCI Express expansion unit from IHV and connect the PCI Express expansion unit to the SPARC M10, the error "IOC register compare error" may be detected. |
Workaround | Set the POST diagnosis level to "off". Perform the following. 1. Power off the physical partition. XSCF> poweroff -p x 2. Set the POST diagnosis level to "off". XSCF> setpparmode -p x -m diag=off |
< Previous Page | Next Page >