Skip to main content

Contents

  1. Preface
  2. Chapter 1 Software Requirements
    1. Click XCP/Oracle Solaris and Required SRUs/Patches
    2.  How to Obtain XCP and Oracle Solaris SRUs/Patches/Oracle VM Server for SPARC
    3.  Web Browser
    4.  Software Supporting Remote Storage
    5.  Obtaining the SAS-2 Integrated RAID Configuration Utility
    6.  Existing XCP Firmware Versions and Support Information
  3. Chapter 2 XCP 2430-Related Information
    1.  Latest Information on XCP 2430
    2. Click Notes and Restrictions
    3.  XCP 2430 Problems and Workarounds
  4. Chapter 3 Information on Software
    1. Click Notes and Restrictions
    2. Click Problems With XCP and Workarounds
    3. Click Problems With Oracle Solaris and Workarounds
  5. Chapter 4 Information on SPARC M10-1 Hardware
    1. Click Notes and Restrictions
    2.  Problems With Hardware and Workarounds
  6. Chapter 5 Information on SPARC M10-4 Hardware
    1. Click Notes and Restrictions
    2.  Problems With Hardware and Workarounds
  7. Chapter 6 Information on SPARC M10-4S Hardware
    1. Click Notes and Restrictions
    2.  Problems With Hardware and Workarounds
  8. Chapter 7 Information on the PCI Expansion Unit
    1.  PCI Expansion Unit Firmware Versions and Support Information
    2. Click Direct I/O Function for the PCI Expansion Unit
    3. Click Problems With the PCI Expansion Unit and Workarounds
  9. Chapter 8 Information on SPARC M10 Manuals

Notes on Using Oracle Solaris 10


Notes on Using Oracle Solaris 10
  1. [SPARC M10-4S]
    When the control domain is running on Oracle Solaris 10 with Oracle VM Server for SPARC version 3.1.0.1 or older, if the physical partition dynamic reconfiguration (PPAR DR) feature is enabled, the ldoms/ldmd service fails to start and Oracle VM for SPARC does not work.
    The PPAR DR feature is enabled at the time of shipment. Therefore, either disable the PPAR DR feature before setting up logical domains or update Oracle VM Server for SPARC to version 3.1.0.1 or later.
    Configuration of the PPAR DR feature is performed with the setpparmode(8) command of XSCF firmware. For details on the setpparmode(8) command, see the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 XSCF Reference Manual.
    To update the Oracle VM Server for SPARC version to 3.1.0.1, apply patch 150817-01 after installing Oracle VM Server for SPARC 3.1.
  2. [SPARC M10-4S]
    When Oracle Solaris 10 is running on the control domain, in order to perform dynamic reconfiguration of physical partitions (PPAR DR) with the deleteboard(8) and addboard(8) commands, update to Oracle VM Server for SPARC 3.1.1 or later. When updating to 3.1.1, apply patch 150817-02 after installing Oracle VM Server for SPARC 3.1.

Top of Page