Skip to main content

Contents

  1. Preface
  2. Chapter 1 Software Requirements
    1. Click XCP/Oracle Solaris and Required SRUs/Patches
    2.  How to Obtain XCP and Oracle Solaris SRUs/Patches/Oracle VM Server for SPARC
    3.  Web Browser
    4.  Software Supporting Remote Storage
    5.  Obtaining the SAS-2 Integrated RAID Configuration Utility
    6.  Existing XCP Firmware Versions and Support Information
  3. Chapter 2 XCP 2430-Related Information
    1.  Latest Information on XCP 2430
    2. Click Notes and Restrictions
    3.  XCP 2430 Problems and Workarounds
  4. Chapter 3 Information on Software
    1. Click Notes and Restrictions
    2. Click Problems With XCP and Workarounds
    3. Click Problems With Oracle Solaris and Workarounds
  5. Chapter 4 Information on SPARC M10-1 Hardware
    1. Click Notes and Restrictions
    2.  Problems With Hardware and Workarounds
  6. Chapter 5 Information on SPARC M10-4 Hardware
    1. Click Notes and Restrictions
    2.  Problems With Hardware and Workarounds
  7. Chapter 6 Information on SPARC M10-4S Hardware
    1. Click Notes and Restrictions
    2.  Problems With Hardware and Workarounds
  8. Chapter 7 Information on the PCI Expansion Unit
    1.  PCI Expansion Unit Firmware Versions and Support Information
    2. Click Direct I/O Function for the PCI Expansion Unit
    3. Click Problems With the PCI Expansion Unit and Workarounds
  9. Chapter 8 Information on SPARC M10 Manuals

Restrictions on Audit


Restrictions on Audit
  1. The log file transfer function of the audit log set with the setaudit archive command and the setaudit disable command is not supported at present.
  2. If the policy for writing to an audit record is set to stop temporarily ("suspend"), degradation due to an error may occur or the XSCF may be reset.
    In the setaudit(8) command, specify overwriting ("count") by default for the write policy for the audit trail. For details on this problem, see "RTIF2-141208-001." From XCP 2250 onwards, specifying "suspend" invokes the same behavior as when "count" is specified.

Top of Page