Skip to main content

Contents

  1. Preface
  2. Chapter 1 Software Requirements
    1. Click XCP/Oracle Solaris and Required SRUs/Patches
    2.  How to Obtain XCP and Oracle Solaris SRUs/Patches/Oracle VM Server for SPARC
    3.  Web Browser
    4.  Software Supporting Remote Storage
    5.  Obtaining the SAS-2 Integrated RAID Configuration Utility
    6.  Existing XCP Firmware Versions and Support Information
  3. Chapter 2 XCP 2430-Related Information
    1.  Latest Information on XCP 2430
    2. Click Notes and Restrictions
    3.  XCP 2430 Problems and Workarounds
  4. Chapter 3 Information on Software
    1. Click Notes and Restrictions
    2. Click Problems With XCP and Workarounds
    3. Click Problems With Oracle Solaris and Workarounds
  5. Chapter 4 Information on SPARC M10-1 Hardware
    1. Click Notes and Restrictions
    2.  Problems With Hardware and Workarounds
  6. Chapter 5 Information on SPARC M10-4 Hardware
    1. Click Notes and Restrictions
    2.  Problems With Hardware and Workarounds
  7. Chapter 6 Information on SPARC M10-4S Hardware
    1. Click Notes and Restrictions
    2.  Problems With Hardware and Workarounds
  8. Chapter 7 Information on the PCI Expansion Unit
    1.  PCI Expansion Unit Firmware Versions and Support Information
    2. Click Direct I/O Function for the PCI Expansion Unit
    3. Click Problems With the PCI Expansion Unit and Workarounds
  9. Chapter 8 Information on SPARC M10 Manuals

Notes on the Power Supply Unit (PSU)


Notes on the Power Supply Unit (PSU)
XCP 2360 or later has two added error log entries on power supply unit (PSU) failures.
If the PSU input power is turned off or an error occurs in the primary circuit of the PSU, the following error log entry is registered.
PSU input power has been lost or the input circuit has failed.(/PSU#x_path)
If this error log entry is registered, check the PSU input power to find out whether the PSU failed.
Also, the following error log entry is registered when the PSU input power is restored.
PSU input power has been recovered.(/PSU#x_path)
The CHECK LED on the operation panel is turned on/off and the specified destination is notified too when either of these error log entries is registered.

Top of Page