Skip to main content
  1. Home >
  2. Products >
  3. Computing Products >
  4. Servers >
  5. Fujitsu SPARC servers >
  6. Downloads >
  7. User Manuals >
  8. Fujitsu SPARC M12 Product Notes for XCP 4010 - 4040 / XCP 3021 - XCP 3130 >
  9. Notes on a Case When Recovery Mode of Oracle VM Server for SPARC is Enabled

Contents

  1. Preface
  2. Chapter 1 Latest Information
    1.  Latest Information
    2.  Revision Information
  3. Chapter 2 Software Requirements
    1. Click Supported Firmware and Oracle Solaris Versions
    2.  Web Browser
    3.  Software Supporting Remote Storage
    4.  XCP and Oracle Solaris Version Supporting Power Aware Dispatcher Function
    5.  How to Obtain XCP and Oracle Solaris SRU/Patch/Oracle VM Server for SPARC
    6. Click Notes on Memory
    7. Click Notes on Mixing Different Hardware
    8.  Obtaining the SAS-2 Integrated RAID Configuration Utility
  4. Chapter 3 Information on XCP
    1. Click Latest Information on XCP
    2.  XCP Firmware Versions and Support Information
    3. Click Notes and Restrictions
    4. Click Problems With XCP and Workarounds
  5. Chapter 4 Information on Oracle Solaris
    1. Click Notes and Restrictions
    2. Click Problems With Oracle Solaris and Workarounds
  6. Chapter 5 Information on SPARC M12 System Hardware
    1. Click Notes and Restrictions
    2.  Problems With Hardware and Workarounds
  7. Chapter 6 Information on the PCI Expansion Unit
    1.  PCI Expansion Unit Firmware Versions and Support Information
    2. Click Direct I/O Function for the PCI Expansion Unit
    3. Click Problems With the PCI Expansion Unit and Workarounds
  8. Chapter 7 Information on SPARC M12 Manuals

Notes on a Case When Recovery Mode of Oracle VM Server for SPARC is Enabled


Notes on a Case When Recovery Mode of Oracle VM Server for SPARC is Enabled
Suppose that you added a building block (PSB) using dynamic reconfiguration of physical partitions in the condition where the domain configuration has been recovered in a degraded configuration. The added resource is not automatically allocated to any logical domain. Allocate the added resource manually. Alternatively, execute the ldm set-spconfig command to select the original domain configuration and then restart the physical partition using the poweron(8) and poweroff(8) commands.

Top of Page