Restrictions and Notes on Power-Saving Operation
Restrictions and Notes on Power-Saving Operation
- Earlier than XCP 3040
The "performance" value is not supported for the -m powermgmt_policy option of the power-saving operation that is set with the setpparmode command. Specify either "disabled" (disable), which is the default value, or "elastic" (enable).
- XCP 3040 or later- When updating firmware from XCP 3040 or earlier to XCP 3040 or later
When specifying the "performance" value for the -m powermgmt_policy option of the power-saving operation that is set with the setpparmode command, change the following in the setpparmode command. Change the -m pad option for the Power Aware Dispatcher function (PAD function) from "off" (disabled) to "on" (enabled) to use Solaris Power Aware Dispatcher.
| Note - If the setting of the PAD function is changed, the logical domain configuration becomes factory-default. Then, logical domain reconfiguration is necessary. Save the configuration information in an XML file in advance. |
- - When the firmware applied at factory shipment is XCP 3040 or later
The default setting of the -m pad option is "on" (enabled).
It is not necessary to change the value of the -m pad option.
< Previous Page | Next Page >