Skip to main content
  1. Home >
  2. Products >
  3. Computing Products >
  4. Servers >
  5. Fujitsu SPARC servers >
  6. Downloads >
  7. User Manuals >
  8. Fujitsu SPARC M12-2 Installation Guide >
  9. 2.4.2 Installation Area for a General Rack

2.4.2 Installation Area for a General Rack


2.4.2 Installation Area for a General Rack
Service areas
Service area requirements vary depending on the rack used.
When mounting the SPARC M12-2 and the PCI expansion unit in the designated rack, see the examples of service areas in Figure 2-2 and Figure 2-3. The rack width depends on the rack used.
When using a rack other than the designated rack, see the manual for the rack used.
Figure 2-2  Example of Service Areas for the SPARC M12-2 (Top View)
Figure 2-2  Example of Service Areas for the SPARC M12-2 (Top View)
Figure 2-3  Example of Service Areas for the PCI Expansion Unit (Top View)
Figure 2-3  Example of Service Areas for the PCI Expansion Unit (Top View)
*1 To mount the PCI expansion unit in the rack, an area with a depth of 1,200 mm (47.2 in.) is required in front of the rack, and areas with a width of 600 mm (23.6 in.) are required on both the left and right sides of the front service area. If there is a possibility that the PCI expansion unit will be added, secure an area with a depth of 1,200 mm (47.2 in.) in front of the rack and areas with a width of 600 mm (23.6 in.) on both the left and right sides of the front service area.