Skip to main content

5.3 Logging In to the XSCF


5.3 Logging In to the XSCF
This section describes the procedure for logging in to the XSCF by using the default XSCF user account.
Log in to the XSCF by using the default user account and authentication method until a user account appropriate to the user environment is registered for you. The default user privileges are useradm and platadm.
Remarks - platadm is mainly used to manage the whole system. useradm is mainly used to manage user accounts. For details on the user privilege types and the privileges, see Table 6-3.
  1. After the system management terminal displays "SCF_READY", press the [Enter] key.
  2. After the login prompt appears, enter "default" for the login name.
login: default
  1. After a message prompting operation of the mode switch appears, operate the mode switch on the operation panel as follows.

    a. Switch the mode switch on the operation panel to the Locked position, and press the RETURN key.
Change the panel mode switch to Locked and press return...
  1. b. Leave the switch in that position for at least 5 seconds.
Leave it in that position for at least 5 seconds.
  1. c. Return the mode switch to the Service position, and press the RETURN key.
Change the panel mode switch to Service and press return...
Note - Complete this switching operation of the mode switch in 1 minute or less. If the operation exceeds 1 minute, login authentication times out.
  1. Confirm that the system management terminal displays the XSCF shell prompt.
XSCF>