Skip to main content
Home
>
Products
>
Computing Products
>
Servers
>
Fujitsu SPARC servers
>
Downloads
>
User Manuals
>
Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 RCIL User Guide
>
Chapter 3 Examples of Remote Power Management Configuration
Contents
Preface
Chapter 1 Overview of the Remote Power Management Function of SPARC M12 and SPARC M10
1.1 About the Remote Power Management Function for SPARC M12 and SPARC M10
1.2 Understanding the Forms of Connection for Remote Power Management
1.3 Remote Power Management Mechanism
Chapter 2 Basic Flow for Configuring Remote Power Management
2.1 Before Configuring Remote Power Management
2.2 Steps for Configuring Remote Power Management
2.2.1 Creating a Management File
2.2.2 Enabling/Disabling the IPMI Service Used for the Remote Power Management Function
2.2.3 Checking the Remote Power Management Settings
2.2.4 Initializing the Remote Power Management Settings
2.2.5 Enabling/Disabling the Remote Power Management Function
2.2.6 Setting a Remote Power Management Group
2.2.7 Acquiring the setting information on a remote power management group
Chapter 3 Examples of Remote Power Management Configuration
3.1 Configuring the Remote Power Management for the First Time
3.1.1 System That is Configured with a Host Node and an I/O Node
3.1.2 System That is Configured with a Host Node and a Remote Power Distribution Unit
3.1.3 System That is Configured with Multiple Host Nodes and a Remote Power Distribution Unit
3.1.4 System That is Configured with Host Nodes, in Which Physical Partitions (PPARs) are Specified as Subnodes, and a Remote Power Distribution Unit
3.1.5 System in Which Multiple Remote Power Management Groups are Set
3.2 Adding or Removing a Node in an Existing Remote Power Management Group
3.2.1 Adding an I/O Node
3.2.2 Adding a Host Node
3.2.3 Removing an I/O Node
3.2.4 Removing a Host Node
3.3 Maintaining an I/O Node
3.3.1 Maintaining an ETERNUS
Table of contents
Glossary
Chapter 3 Examples of Remote Power Management Configuration
Chapter 3 Examples of Remote Power Management Configuration
This section describes how to configure the remote power management in the following cases.
Configuring the Remote Power Management for the First Time
Adding or Removing a Node in an Existing Remote Power Management Group
Maintaining an I/O Node
<
Previous Page
|
Next Page
>
Top of Page