Skip to main content
  1. Home >
  2. Products >
  3. Computing Products >
  4. Servers >
  5. Fujitsu SPARC servers >
  6. Downloads >
  7. User Manuals >
  8. Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 RCIL User Guide >
  9. 3.2 Adding or Removing a Node in an Existing Remote Power Management Group

3.2 Adding or Removing a Node in an Existing Remote Power Management Group


3.2 Adding or Removing a Node in an Existing Remote Power Management Group
The following shows how to add or remove a node in an existing remote power management group.
Figure 3-13  Flow when Adding/Removing a Node in an Existing Remote Power Management Group
Figure 3-13  Flow when Adding/Removing a Node in an Existing Remote Power Management Group
In the following sections, how to configure the remote power management is described by using the system configurations below as examples.