Skip to main content

Contents

  1. Preface
  2. Chapter 1 Overview of the Remote Power Management Function of SPARC M12 and SPARC M10
    1.  1.1 About the Remote Power Management Function for SPARC M12 and SPARC M10
    2.  1.2 Understanding the Forms of Connection for Remote Power Management
    3.  1.3 Remote Power Management Mechanism
  3. Chapter 2 Basic Flow for Configuring Remote Power Management
    1.  2.1 Before Configuring Remote Power Management
    2. Click 2.2 Steps for Configuring Remote Power Management
  4. Chapter 3 Examples of Remote Power Management Configuration
    1. Click 3.1 Configuring the Remote Power Management for the First Time
    2. Click 3.2 Adding or Removing a Node in an Existing Remote Power Management Group
    3. Click 3.3 Maintaining an I/O Node

2.2.4 Initializing the Remote Power Management Settings


2.2.4 Initializing the Remote Power Management Settings
To initialize the contents of the remote power management settings, use the clearremotepwrmgmt command of the XSCF firmware.
XSCF> clearremotepwrmgmt [-a|-G groupid]
To initialize the settings of all the remote power management groups, specify -a. To indicate a remote power management group, specify a group ID with the -G option. If -a and -G options are omitted, then the -a option is used by default.

Top of Page