Skip to main content
  1. Home >
  2. Products >
  3. Computing Products >
  4. Servers >
  5. Fujitsu SPARC servers >
  6. Downloads >
  7. User Manuals >
  8. Fujitsu M10-1/SPARC M10-1 Installation Guide >
  9. 6.5.2 Setting an Ethernet (XSCF-LAN) IP address

6.5.2 Setting an Ethernet (XSCF-LAN) IP address


6.5.2 Setting an Ethernet (XSCF-LAN) IP address
The XSCF-LAN is a LAN established for user access to the XSCF. Two XSCF-LAN ports can be used, depending on the network configuration.
For the SPARC M10-1, set either or both of the following IP addresses:
- XSCF-LAN#0 of BB#00

- XSCF-LAN#1 of BB#00
Figure 6-1  Example of XSCF-LAN settings
Figure 6-1  Example of XSCF-LAN settings
Remarks - Configure the XSCF-LAN#0 and XSCF-LAN#1 ports such that they are on different subnets. (See (1) in Figure 6-1.)
  1. Execute the setnetwork command with network interface information specified.
    The following example sets the IP addresses and net masks for XSCF-LAN#0 and XSCF-LAN#1 of BB#00 to enable them.
XSCF> setnetwork bb#00-lan#0 -m 255.255.255.0 192.168.1.x
XSCF> setnetwork bb#00-lan#1 -m 255.255.255.0 192.168.2.a